Foam sheets are cut to order from our own cast blocks

Spray foam is applied pre jib and once all electrical wiring and plumbing has usually taken place.

External wall polyurethane spray foamed. The studs were then cleaned back ready for gib.

Ceiling being sprayed with 75mm polyurethane foam.

Windows are masked to prevent overspray. Notice the water pipes get insulated at the same time.

In this case the roof was coated with foam- some people prefer the top side of the gib ceiling to be coated instead.

Industrial coolstores are one of our specialities, we have completed many jobs throughout the South Island.

Fishing boat freezer hold.Walls were spray foamed then clad and were finished with injected foam.

Foam sheet on the ceiling , then foam spray was applied to fill gaps.The excess was then removed and cladding installed.

Floor area of this hold was also filled with bouyancy foam and then croncrete added for ballast

Ceiling before excess spray foam was trimmed

Ceiling of the freezer hold using foam sheet as a base then gaps spray foam filled.

Large coolstores like this one require the use of a sissor lift . Sometimes the use of a Cherry picker is needed.

Polyurethane spray can be applied directly to the tilt slab. There was no shortage of it on this building.

Doors , fans ,cooling units and other items are covered to prevent overspray.

When installed correctly and at the correct thickness, huge savings in power consumption can be made-to the point which even smaller cooler units can be used to obtain the same level of temperature.